Skip to content

Proudly American · Family owned and run in Spring Hill

(352) 663-0381

Gas Fire Pit and Fire Table Repair in Spring Hill, FL

A fire pit that lights on the first try and stays lit, with the fault found at the burner, the pilot or the gas supply.

  • Available for same-day service
  • Fully licensed and insured
  • Family owned and run
  • Locally owned and operated

Request a Free Inspection

Quicker by phone? Call (352) 663-0381

Same-day service available, call now

(352) 663-0381 Get a Free Inspection

10% Off Work Booked in the 72 Hours After Your Inspection

Book your gas fire pit repair within 72 hours of your free inspection and take 10% off.

What You Can Count On

Gas fire pit repair diagnoses an outdoor fire pit or fire table that will not light, will not stay lit or burns low. The usual causes are a fouled igniter or thermocouple, spider webs in the burner orifice, too much rock or glass over the burner, water in the pan, a failing valve, or a gas supply problem.

  • Available for same-day service

    Same-day service is available when the pit will not light before a gathering.

  • Upfront, honest pricing

    Parts and labor are named before anything is replaced.

  • Locally owned and operated

    A local crew that tells you when the fault is in the gas line, not the pit.

What Gas Fire Pit Service Covers

A gas fire pit or fire table is a burner in a pan, a lighting system, a gas valve and a supply line, set into an enclosure and covered with lava rock or fire glass. Florida's Fuel Gas code, section 635.1, says a permanently fixed outdoor decorative appliance like this is listed to ANSI Z21.97 and installed to its maker's instructions, so repairs follow that maker's manual and parts.

Gas fire pit service covers the whole chain: the igniter and pilot, the thermocouple that proves the flame, the valve, the burner and its orifice, the media over it, the drainage under it, and the supply pressure arriving at the valve. A fire pit igniter replacement uses the maker's own part. We do not build new fire pits or run new gas lines; those are separate trades.

Why a Fire Pit Will Not Light or Stay Lit

One fire pit burner maker's troubleshooting table covers the usual faults, and it is a good map. When the pit will not light, the gas line may need bleeding, a supply valve may be closed, or too much media is piled over the burner and smothering the gas. When the flame is low, the media may be too fine or too deep, a valve may be only partly open, or spider webs may be blocking the burner orifice.

When the fire shuts off after a short time, the same manual names three causes: wind gusts that blow out the pilot, too much media packed around the pilot so the thermocouple overheats, and running the pit before it dries out after heavy rain. A whistle usually means media packed around the burner tube or a connector that is not the non-whistling type.

Before booking an outdoor fire pit repair, you can safely check three things yourself: that the supply valve is fully open, that the pit is dry, and that rock or glass sits no deeper over the burner than the manual allows. If you smell gas, turn the supply off, do not try to light it, and call.

Faults on a Long Buried Gas Run

Where a fire pit sits out in the yard of a detached house, well away from the walls, it is fed by a gas line buried under the lawn or patio. That distance shows up in the faults. After any work on the line, air in a long run has to be bled before gas reaches the burner, which is the first item in the maker's won't-light list. A run that is long for its pipe size can starve the burner: the maker's manual sets a minimum inlet pressure at the valve and sizes the supply pipe by its length in its charts.

So when a fire pit far from the house burns low even with clean ports and correct media, we measure the pressure at its valve. If the supply cannot deliver it, the fix is in the line, which is work for a plumber or gas contractor. We tell you that plainly instead of swapping parts that are not at fault. Every connection we disturb is leak tested before the pit is used, as the manual requires.

Bottled Gas or Utility Gas

The Census Bureau's 2020 to 2024 survey counts an estimated 978 Spring Hill homes that heat mainly with utility gas and 263 that heat with bottled or tank gas. Those are heating figures, not fire pit counts, but they show both fuels are in use here, and a fire pit runs on one or the other.

The fuel matters for repair. A pit is built as natural gas or propane, and that maker says its models cannot be field converted from one to the other. On propane, the same manual keeps the tank outside the fire pit enclosure and calls for a tank of at least 100 pounds for its pits, because a small tank cannot keep up. On utility gas, the supply comes from the meter, and pressure problems are traced back along the line. We do not fill or sell propane tanks.

Water, Media and Ventilation

A fire pit outdoors in Florida takes on rain. The maker's manual asks for drainage in the enclosure, cross ventilation of at least 18 square inches per side, and clear weep holes in the pan; dust from cheap media blocks those holes and leaves water standing. We clean the pan, clear the holes and reset the media to the depth the burner needs. That is the core of gas fire pit maintenance in a wet climate. A cover over the pit when it is not in use helps, and our guide on how to clean fire pit covers the routine care between visits.

For a gas fire pit or gas fire table repair, the free inspection tests the lighting system, clears the burner and checks the supply. No part is ordered before you approve a written estimate. We are locally owned and family-run, Proudly American, with an experienced crew; indoor units are covered under gas fireplace repair.

Problems We Find and Fix

Pilot will not stay lit
Thermocouple, wind or wet media. We find which and fix it.
Low or uneven flame
Spider webs or packed media. We clear the orifice and reset the media.
Water in the pit
Weep holes blocked by media dust. We clean them and the pan.

Repair Options

Where the fault sits decides the repair.

Pilot goes out after a few minutes

Clean or replace the thermocouple, reset media around the pilot

Wind and wet media are ruled out first.

Low flame with clean ports

Measure supply pressure at the valve

A starved line is referred to a plumber or gas contractor.

Valve or igniter failed

Replace with the maker's approved part

Model read from the burner's rating label.

Parts and Materials

Thermocouple and pilot parts
The maker's approved parts for the burner system.
Igniter and valve
Replaced only with approved components.
Lava rock or fire glass
Sized and spread to the depth the burner needs.
Leak test solution
Soapy water on every connection we disturb.

What Affects the Price

Which part failed
Cleaning costs less than a new valve or ignition system.
Part availability
Some burners need parts ordered from the maker.
Media replacement
Dusty or wrong-size media is replaced by the bag.
Supply problems
Line work is quoted separately by a plumber.

Request Your Free Spring Hill Inspection

Leave your details and we will call back to pick a time that suits you.

(352) 663-0381
  • Free inspection and a written estimate
  • Same-day service available
  • Family owned and run in Spring Hill

Tell us what the chimney or fireplace is doing and we will phone to arrange the free inspection.

Signs It Is Time

A gas fire pit sits outside through every storm, and the faults show up as a click with no flame, a pilot that dies in the wind, or a flame that never gets tall. Our local, family-owned crew traces the problem from the burner back to the gas supply and fixes it with the maker's parts. The first look is free.

  • The igniter clicks but no flame appears
  • The pilot lights, then goes out when you let go
  • The flame burns low or only on one side
  • The fire shuts off after a few minutes
  • Water standing in the burner pan after rain

Questions and Answers

Why does my gas fire pit pilot go out after a few minutes?
One fire pit maker's manual names three usual causes. Wind gusts blow out the pilot, and media packed around the pilot overheats the thermocouple. A pit lit before it dries after heavy rain loses its flame. If none of those applies, the thermocouple or valve is tested next.
Why is my fire pit flame so low?
Check first that every supply valve is fully open. Then look at the media, because rock or glass that is too fine or too deep over the burner chokes the flame. Spider webs in the burner orifice are another cause the maker lists. On a long buried line, low pressure at the valve may be the fault.
Can a propane fire pit be switched to natural gas?
Only if the maker allows it. One maker's manual says its fire pit burners ship as natural gas or propane models and cannot be field converted from one to the other. The burner's rating label shows the gas type. A conversion, where one exists, uses the maker's own pilot, orifice and gas valve parts.
Why does my gas fire pit whistle?
A whistle usually comes from media packed too tightly around the burner tube, or from a flexible gas connector that is not the non-whistling type. Loosening and resetting the rock or glass around the burner fixes the first. A whistling connector is replaced.

Proudly American

Run by a Spring Hill family: experienced hands, a written estimate before work starts and a workmanship warranty on our repairs.

Call Now (352) 663-0381

Equipment Brands We Install and Service

RutlandCopperfield Chimney SupplyHeatilatorHeat & GloDuraVentOlympia Chimney and Venting

Get Your Fire Pit Lighting Again

From burner to supply, our Proudly American family crew traces the fault and fixes the right part.

Call Now (352) 663-0381